Gh Razaghian; A Beitollahi; M Pourkermani; M Arian
Abstract
Iran is in the middle part of the seismic belt of Alps-Himalayas with dissimilar geological, structural and seismological features. In the present article, zonation maps of the earthquake occurrence rate (Rate) and the largest observed earthquakes (Mmax) have been prepared for all the regions of Iran. ...
Read More
Iran is in the middle part of the seismic belt of Alps-Himalayas with dissimilar geological, structural and seismological features. In the present article, zonation maps of the earthquake occurrence rate (Rate) and the largest observed earthquakes (Mmax) have been prepared for all the regions of Iran. The parameter (Rate) shows the number of occurred earthquakes in the year in the region of Iran. Subsequently, according to the zonations, classification of different regions with different seismic activities will be achievable. The zonation map of earthquake occurrence frequency (Rate) in the present article shows that trend of the main classified zonations, according to the calculations, is similar with the geological and structural features of the region. It seems that zonation of Zagros and certain parts of the east of Alborz and Kopedagh with the maximum rate of earthquakes are drastically different with the zonation of central parts of Iran, Makran and eastern part of Iran with low seismic activities. In addition to zonation maps of the earthquake occurrence rate, zonation of the largest observed earthquakes (Mmax) has been provided in this region as well. According to the map, different regions of the Central part of Iran and Alborz with large seismic activities are different with other regions of Iran. Having compared the two zonation maps in this article, it is possible to classify the seismic activities of different regions. The seismic data and the basis of the article are according to the National and International Seismology catalogue for a period of 1900 to 2008.
M. Talebian; S. H. Tabatabaei; M. Fattahi; M. Ghorashi; A. Beitollahi; A. Ghalandarzadeh; M.A. Riahi
Abstract
The Iranian plateau lies between the Arabian and Eurasian plates and accommodates approximately 22 mm/yr of N-S shortening. About 9 mm/y of this shortening is taken up by folding and thrusting in the Zagros while the remaining 13 mm/yr is taken up in the Alborz and Kopeh-Dagh. The Central Iran ...
Read More
The Iranian plateau lies between the Arabian and Eurasian plates and accommodates approximately 22 mm/yr of N-S shortening. About 9 mm/y of this shortening is taken up by folding and thrusting in the Zagros while the remaining 13 mm/yr is taken up in the Alborz and Kopeh-Dagh. The Central Iran block is relatively stable and thus moves to the north with an average velocity of about 13 mm/y. As the stable Afghanistan block lies to the east, the northward motion of Central Iran produces a right-lateral shear in eastern Iran, which is distributed mainly over a few major faults to the west (~5 mm/yr) and east (~ 8 mm/yr) of the Lut desert. Limited information is available about the slip rates of individual faults in eastern Iran; therefore in this study we try to combine all geological, geodetic and available Quaternary dating results to estimate the fault slip rates and distribution of active deformation in eastern Iran. Finally, we report the results from OSL dating of samples taken from uplifted plain deposits near the south end of the Bam-Baravat fault. These results show that this fault is growing in the vertical direction with at a rate of ~ 0.5 mmy-1. Considering geometric relation between the Bam-Baravat and the south Bam earthquake fault, we estimate a slip rate of about 2 mm/y for the south Bam earthquake fault.