Kh. Motaghi; A. R. Ghods; H. R. Siahkoohi
Abstract
Study of ground motion attenuation in Tehran region is a very important aspect of determining a more precise hazard map of the city. For the last 10 years, three short period seismic networks have been operating in the study region by the Institute of Geophysics, University of Tehran (IGUT). We ...
Read More
Study of ground motion attenuation in Tehran region is a very important aspect of determining a more precise hazard map of the city. For the last 10 years, three short period seismic networks have been operating in the study region by the Institute of Geophysics, University of Tehran (IGUT). We have selected 47 events recorded by IGUT stations during 1996-2004 to estimate attenuation parameters for the study area. The selected events have provided 480 records with good spatial resolution. Only records with signal-to-noise ratio of greater than 4 have been selected. To find the distances at which the nature of geometrical spreading attenuation (R-b) changes significantly, we use a local regression smoothing method called Robust Lowess. It is found that a tri-linear function having hinges at distances about 106±10 and 191±10 km describes the geometric spreading attenuation with distance. Using a tri-linear regression analysis, we found that b1=1.1±0.1, b2=-0.4±0.1, b3=0.5 minimize the average absolute value of the residuals at a frequency of 4 Hz. The remaining attenuation is assumed to be caused by anelasticity. Using anelastic attenuation at different frequencies, the quality factor in Tehran region is obtained as .
Y. Sharghi; F. Alinia; H. R. Siahkoohi
Abstract
Seismic travel time tomography uses seismic waves to image velocity distribution inside the ground. This method has been widely applied to practical applications in many fields including earth sciences. In this method, first-arrival times of seismic waves due to artificial sources, observed at receivers ...
Read More
Seismic travel time tomography uses seismic waves to image velocity distribution inside the ground. This method has been widely applied to practical applications in many fields including earth sciences. In this method, first-arrival times of seismic waves due to artificial sources, observed at receivers in the vicinity of the exploration target are analyzed to obtain the velocity distribution within the propagation area. This paper describes the seismic tomography investigation performed at the abutments of Bakhtyari Dam site. The study aimed to find the low-velocity zones that may correspond to jointed media where seepage most likely happens. We performed 3-D tomographic inversion on Bakhtiari dam seismic data. To perform ray tracing and travel-time computation at each iteration, we used Um and Thurber (1987) method and for inversion step we used SIRT method. In most of the tomograms, average velocity was 3km/s. According to the Barton relation (2006) the seepage potential in dam sit abutments, is low. A low velocity zone has been detected above the 690 m level in right abutment. It shows that the weak zones extended from surface down to this level. Despite the presence of some weak zones, the rock mass quality is good, and the design of the grout curtain could help to bypass the reservoir water away from these seepage paths
