Tectonics
Mohammad Amir Alimi
Abstract
This paper presents the results of a field study aiming to describe and to interpret origin of the vein network in the south of Birjand. Adjacent to Birjand ophiolite in eastern Iran, the Paleocene-Eocene flysch facies was deposited in the Birjand foreland area concomitant with the Alpine orogeny (Laramide). ...
Read More
This paper presents the results of a field study aiming to describe and to interpret origin of the vein network in the south of Birjand. Adjacent to Birjand ophiolite in eastern Iran, the Paleocene-Eocene flysch facies was deposited in the Birjand foreland area concomitant with the Alpine orogeny (Laramide). The sandstone unit of this facies contain two orthogonal sets of quartzite veins. The N310-340 striking veins (set 1) are arranged parallel to the Bagheran Kuh range front and perpendicular to the vein set 2 (N215-240). The paleostress reconstruction in the Paleocene-Eocene shows that the regional compression direction N240 is perpendicular to the Bagheran Kuh range front. Structurally, to create orthogonal veins, σ1 should be perpendicular to the layering and σ2 and σ3 should be horizontal. This situation was created in the middle Eocene-Oligocene. The post-collision extensions of this period caused a decrease in regional pressure in the region. As a resault, the maximum principal stress (σ1), was changed to a vertical state and intermediate stress (σ2) was parallel to the orogenic pressure. In these conditions, orthogonal tensile openings (state I) were formed as a result of the local inversion of stress and fluid pressure in the flysch facies.
Tectonics
MohammadAmir Alimi
Abstract
The Bahlgerd shear zone in the northern margin of Bagheran Mountain is separated Eocene flysch from the Cretaceous ophiolite sequence and Quaternary sediments by southern Birjand and Bahlgerd faults. In the deformation evaluation , sigmoidal array arrays located in sandstone units have been used as strain ...
Read More
The Bahlgerd shear zone in the northern margin of Bagheran Mountain is separated Eocene flysch from the Cretaceous ophiolite sequence and Quaternary sediments by southern Birjand and Bahlgerd faults. In the deformation evaluation , sigmoidal array arrays located in sandstone units have been used as strain markers. Based on the geometry of these arrays, the mathematical equations and R-θ' diagrams of the strain parameters were estimated. The mean values of shear strain (γ), volume change (∆) and convergence across the zone (K) are 0.45, -0.26 and 0.85, respectively. The plotting strain ellipses on the logarithmic Flinn diagram are in the field of flattening, which indicates the simultaneous simple shear and compaction in the region and show a volume reduction of up to 30%. Also, in the Bahlgerd shear zone, the value of θ'> 45 ° and cleavages are created in the direction perpendicular to the opening of the veins, which conforms to the characteristics of the compactional simple shear model. The horizontal strain parameters in the transpression model have similar values the compactional simple shear model. Based on the calculated convergence parameter (0.39), Behlgard shear zone is in the category of slightly convergence zones in which the amount of shortening
